BAS 100B/W - Page 25

2-14
Cell Stand
The BAS 100B/W can control the purging and
stirring for BAS Cell Stands and the BAS
Controlled Growth Mercury Electrode (CGME).
The knock/dispense routines for the
SMDE
and
CGME
modes of the Mercury Electrode are also
controlled by the BAS 100B/W, so the
Cell Stand
option must be set accordingly (the
SMDE
option
can also be used for the PAR 303A SMDE).
The other parameters in the
Setup
dialog box are discussed in Section 3 (see page
3-4).
Once the
Setup
communication parameters have been checked, the
Electrochemical Analyzer can be powered up. The system is now ready for use.
Printer/Plotter Configuration
Although a printer/plotter can be selected using the
Print
Options dialog box (see
Section 9.2), the appropriate driver must first be installed. The drivers for older
models of printers/plotters are contained on the Windows 3.x disks, and are
installed using the Printer dialog box in the Control Panel. However, the drivers
for more recent models have to be provided by the printer manufacturer, and
require a different method of installation; however, explicit instructions are
typically provided with the printer, so installation should cause no problems.