AW00061111000 Next Steps
Installation and Setup Guide for ace CL, aviator, beat, pilot, racer, runner, and scout Cameras (Windows) 59
If you are using a GigE, USB, or Camera Link camera and the camera is not shown in the
Devices pane, you can use the pylon IP Configurator, the pylon USB Configurator, or the pylon
CL Configurator to check and configure the device.
For more information about these tools, see the following sections:
IP Configurator: Section 4.6.4 on page 33.
USB Configurator: See the Basler Product Documentation available at
docs.baslerweb.com.
CL Configurator: Section 6.5 on page 54.
3. Double-click your camera’s name in the Devices pane to open the camera connection.
4. In the menu bar, click Camera > Continuous Shot to place the camera into continuous image
capture mode.
The images captured by the camera will be displayed in the image display area.
5. In the menu bar, click View > Zoom to Fit to make the image fit into the image display area.
6. Focus the lens until the image is properly focused.
If you vary the light intensity on the object, the camera will automatically adjust the image quality.
This happens because the auto gain and exposure controls are running continuously.
Now that you have started capturing images, you should familiarize yourself with the camera’s
parameter settings. In the Features pane, click the + icon next to your camera’s name. A list of
setting categories will appear.
To Next Page
Loading...
