Basler GigE VISION CAMERAS User Manual

AW00118303000 Acquisition Control
Basler racer GigE 143
Case 1
This is the simplest case, i.e., the Shaft Encoder Reverse Counter Max is set to zero. In this
situation, the reverse counter never increments or decrements and it will have no effect on the
operation of the encoder software module.
When the Shaft Encoder Reverse Counter Max is set to zero:
 If the Shaft Encoder Module Mode is set to Forward Only, the software module will output a
trigger signal whenever it receives a forward tick from the shaft encoder, but not when it
receives a reverse tick.
 If the Shaft Encoder Module Mode is set to Any Direction, the software module will output a
trigger signal whenever it receives either a forward tick or a reverse tick from the shaft encoder.

Basler GigE VISION CAMERAS Specifications

General

Brand	Basler
Model	GigE VISION CAMERAS
Category	Digital Camera
Language	English