AW00118303000 Physical Interface
Basler racer GigE 53
7.3 Connector Types
7.3.1 6-pin Connector
The 6-pin connector on the camera is a Hirose micro receptacle (part number HR10A-7R-6PB) or
the equivalent.
The recommended mating connector is the Hirose micro plug (part number HR10A-7P-6S) or the
equivalent.
7.3.2 12-pin Connector
The 12-pin connector on the camera is a Hirose micro receptacle (part number HR10A-10R-12P)
or the equivalent.
The recommended mating connector is the Hirose micro plug (part number HR10A-10P-12S) or the
equivalent.
7.3.3 RJ-45 Jack
The 8-pin jack for the camera’s Ethernet connection is a standard RJ-45 connector.
The recommended mating connector is any standard RJ-45 plug.
Cables terminated with screw-lock connectors are available from Basler. Contact your Basler sales
representative to order cable assemblies. Suitable cable assemblies are also available from the
Intercon 1 division of Nortech Systems, Inc.
To ensure that you order cables with the correct connectors, note the horizontal orientation of the
screws before ordering.
Green and Yellow LEDs
This RJ-45 jack on the camera includes a green LED and a yellow LED.
When the green LED is lit, it indicates that an active network connection is available.
When the yellow LED is lit, it indicates that data is being transmitted via the network
connection.
To Next Page
Loading...
Need help?
General
