AW00118303000 Specifications, Requirements, and Precautions
Basler racer GigE 7
1.4 Mechanical Specifications
1.4.1 Camera Dimensions and Mounting Points
The cameras are manufactured with high precision. Planar, parallel, and angular sides guarantee
precise mounting with high repeatability.
The camera housings conform to the IP30 protection class provided the camera front is covered by
the protective plastic seal that is shipped with the camera.
The camera’s dimensions in millimeters are as shown in the drawings below.
Camera housings are equipped with four mounting holes (4 x M4; 6.3 deep) on the front and two
mounting holes (8 x M4; 6.3 deep) on each side as shown in the drawings. Four additional holes
(4 x M2.5; 3.3 deep) are present on the camera front for mounting the lens mount adapter.
To Next Page
Loading...
Need help?
General
