Parameter manual b maXX
®
1000
Document no. 5.07004.03 Baumüller Nürnberg GmbH
10
of 208
m Device control status
n NOT READY TO START
m The electronics are voltage-supplied
m Initialization is running
m Drive operation is inhibited
m Drive is not ready to run
n INHIBIT START
m Software/hardware initialization is completed
m Application can be reparameterized
m Drive function is inhibited
m Switch-on is inhibited
m Drive is ready to operate
n READY TO SWITCH ON
m Application can be reparameterized
m Drive function is inhibited
m Operation is enabled
m Drive is ready to operate
n SWITCHED ON
m Application can be reparameterized
m Drive function is inhibited
m At automatic operation holding brake the drive is carrying current before transition
in OPERATION ENABLED.
m Power unit is ready for use, there is supply voltage
m Drive is ready to operate
n OPERATION ENABLED
m Application can be reparameterized
m Drive operation is enabled
m Drive is ready to operate
n QUICKSTOP ACTIVE
m Application can be reparameterized
m Quickstop function is active
m Drive operation is enabled
m Drive is ready to operate
To Next Page
Loading...