Baumuller b maXX 1000 - Appendix B - PLCopen Motion Control; B.1 Hardware

165
of 208
Parameter manual b maXX
®
1000
Document no. 5.07004.03
APPENDIX B - PLCOPEN MOTION CONTROL
B.1 Hardware
The Status LEDs of the CANopen-Slave for b maXX
®
1000.
Turning on and initializing the CANopen slave
After the switch on, the H3 color in sequences red, green, light up, briefly on.
The CANopen slave is then initialized.
m Start Initialization: H3 blinking in orange color
m End Initialization: H3 single flash in orange color
m Initialization ready: H3 orange color off
In this way, the basic initialization of the option module CANopen slaves is completed,
if a mistake occurred during initialization, the H3 flashes in red color.
n blinking
n single flash
ON
OFF
200 ms
200 ms
ON
OFF
200 ms
1000 ms