Baumuller b maXX 1000 - Page 167

PLCopen motion control
Parameter manual b maXX
®
1000
Document no. 5.07004.03
167
of 208
n single flash (red)
n single flash (green)
n double flash (red)
n triple flash (red)
Figure 66: Indicator states and flash rates
CANopen error display via digital keypad
cc01 At least one of the error counters has reached warning level
cc02 „Guard“ (NMT master or NMT slave) or „Heartbeat“ event
cc03 Sync message hasn‘t received within the configured communication cycle
cc04 No communication between CAN interface and CANopen master
cc05 Hardware failure or no CANopen hardware available on processing unit
cc06 No CANopen software available on processing unit
cc07 A newer CANopen software is necessary
cc08 Hardware error
ON
OFF
200 ms
1000 ms
ON
OFF
200 ms
1000 ms
ON
OFF
200 ms
1000 ms
200 ms
200 ms
ON
OFF
200 ms
1000 ms
200 ms
200 ms
200 ms
200 ms