Baur DTA 100 C - Page 88

To Next Page

To Previous Page

Index DTA 100 C

88 / 90 822-129-8

USB interface • 17

User-defined measurement • 51

Using this manual • 6

View Settings • 7

Warranty and After Sales • 82

Withstand voltage template • 53

Main Page

Default Chapter3
- Table of Contents3
1 About this Manual6
- Using this Manual6
- Applicability of the Instructions6
- Structure of Safety Instructions6
- View Settings7
- Note on the Screenshots and Graphics Used8
2 For Your Safety9
- Instructions to the User9
- Intended Use10
- Avoid Dangers, Take Safety Measures10
  - Dangers When Working with Electric Voltage11
- Special Personal Protective Equipment12
3 Product Information13
- Full Illustration13
- Operating and Display Elements16
- USB Interface17
- Power Supply17
- Rating Plate18
4 Technical Data19
5 Basic Insulating Oil Test Procedure20
6 Operating the Oil Breakdown Voltage Tester21
- Menu Navigation21
- Entering Numbers21
- Symbols and Abbreviations on the Display22
- Main Menu23
- Information on the Oil Breakdown Voltage Tester24
  - Information on the USB Interface24
7 Commissioning25
- Checks to Perform before Commissioning25
- Installing the Oil Breakdown Voltage Tester26
- Earthing the Oil Breakdown Voltage Tester26
- Replacing the Electrodes27
- Clean the Electrodes28
- Setting an Electrode Gap28
- Fill and Use the Test Vessel29
  - Instructions for Sampling30
  - Insert the Test Vessel31
- Turning on the Oil Breakdown Voltage Tester32
8 Device Settings33
- Set Display Brightness33
- Select Language34
- Switch Printer On/Off34
- Overwrite Measurement Logs35
- Configure the IEC 60156:2018 Settings35
- Configure the ASTM Settings39
  - Display Individual Breakdown Values39
  - Set the Hold Time before the First Measurement40
- Configure Settings for User-Defined Measurements41
- Set Date42
- Set Time43
- Reset Settings43
9 Standardised Measurement44
- Overview of Standards44
- Carry out a Standardised Measurement45
10 Quick Test48
11 User-Defined Measurement51
- Creating a User-Defined Measurement52
- Running a User-Defined Measurement61
- Editing or Deleting a User-Defined Measurement63
12 Display of Measurement Results64
- Measurement Log as Printout65
- Measurement Log on the Display66
13 Putting the Device out of Operation67
14 BAUR ITS Lite Software for Measurement Data Management68
- Description of Function68
- Installing ITS Lite69
- Starting ITS Lite69
15 Checking the Measurement Accuracy of the Oil Breakdown Voltage Tester (Optional)70
16 Maintenance71
- Cleaning the Oil Breakdown Voltage Tester72
- Replacing the Printer Paper Roll74
- Replacing the Printer Ink Ribbon76
- Replacing the Fuse77
- Calibration77
- Ordering Accessories and Spare Parts78
17 Faults79
- Troubleshooting79
- Error Messages and Corrective Measures80
18 Transportation and Storage81
- Packaging81
- Transportation81
- Storage82
19 Warranty and after Sales82
20 Disposal83
- Disposing of the Device83
- Disposing of the Insulating Oil83
21 Delivery Includes and Options84
22 Declaration of Conformity85
23 Index86

Baur DTA 100 C - Page 88

Table of Contents

Related product manuals