RPC SERIES OWNER’S MANUAL
RPC SERIES QUICK START (RPC-2 MD01 AND RPC-2 RDR)
________________________________________________________________________________
6
Using the RJ04X007 (RJ-11) modular cable,
connect either port labeled “LINE” on the
RPC unit to the telco wall jack. Using
another RJ04X007 (RJ-11) modular cable,
connect the remaining port labeled “LINE”
on the RPC unit to the port labeled “LINE”
on the external modem.
Using the 25MRJ45MD-8 adapter and the
RJ08X007 (8-pin crossed) cable, connect the
DB-25 female port of the modem to the
RJ-45 port labeled “EIA-232” on the back of
the RPC unit.
OPERATION
Accessing Main Menu
Power on the RPC unit. The following
status menu appears:
RPC-2 Series
(c) 1997 by BayTech
F2.07
Circuit Breaker : On
1) . . . OUTLET 1 : Off
2) . . . OUTLET 2 : Off
3) . . . OUTLET 3 : Off
4) . . . OUTLET 4 : Off
5) . . . OUTLET 5 : Off
6) . . . OUTLET 6 : Off
RPC >
If the status menu fails to appear, ensure
the correct cables and adapters are being
used and that they are connected properly.
Also, verify the serial communication
parameters are correctly configured.
To Next Page
Loading...
Need help?
General