BayTech RPC-2 - Enable;Disable Confirmation

RPC SERIES OWNER’S MANUAL
DETAILED OPERATION AND CONFIGURATION
________________________________________________________________________________
25
Enter the number of the outlet you want to
change. If you want to change the name of
Outlet 4, type the number 4 at the “Enter
Request” prompt, followed by <cr>. The
RPC responds:
Enter:
Enter a new receptacle name (maximum
field length, 10 characters), followed by
<cr>. If you want to change the name of
Receptacle 4 from Outlet 4 to Router 1, type
Router 1 from the “Enter” prompt, followed
by <cr>. The RPC responds with the outlet
name menu displaying the name change to
Outlet 4:
1) . . . OUTLET 1
2) . . . OUTLET 2
3) . . . OUTLET 3
4) . . . Router 1
5) . . . OUTLET 5
6) . . . OUTLET 6
Enter Request:
To return to the RPC > prompt, press any
key at the “Enter Request” prompt.
Enable/Disable
When a command is sent to TURN ON,
Confirmation
TURN OFF, OR REBOOT a receptacle, if
the enable/disable confirmation feature is
enabled, the RPC responds, asking you to
confirm the command. For example, if the
command “ON 3” is sent, and the
enable/disable confirmation is enabled, the
RPC responds:
Turn On Outlet 3? (Y/N)
If the enable/disable feature is disabled, the
RPC will not ask to confirm the command.