RPC SERIES OWNER’S MANUAL
DETAILED OPERATION AND CONFIGURATION
________________________________________________________________________________
29
OPERATION
The RPC’s main menu allows you to
monitor and control equipment attached to
each of the RPC-2 RDR and RPC-2 MD01’s
six receptacles. From this menu, you can
turn on, turn off, or reboot attached
equipment, individually, or all equipment,
simultaneously.
The RPC recognizes three basic operating
commands: ON n<cr>, OFF n<cr>, and
REBOOT n<cr>, where n represents the
outlet number.
There are six red LEDs on the front of the
RPC unit. There is a corresponding red
LED for each of the RPC’s six receptacles.
When the LEDs are illuminated,
corresponding receptacle(s) are turned
"ON," and consequently, attached
equipment is receiving power. If the LED’s
are not illuminated, corresponding
receptacle(s) are turned “OFF.”
Accessing Main Menu
Power on the RPC unit. The following
outlet and circuit breaker status menu
appears:
RPC-2 Series
(c) 1997 by BayTech
F2.07
Circuit Breaker : On
1) . . . OUTLET 1 : Off
2) . . . OUTLET 2 : Off
3) . . . OUTLET 3 : Off
4) . . . OUTLET 4 : Off
5) . . . OUTLET 5 : Off
6) . . . OUTLET 6 : Off
RPC >
To Next Page
Loading...
Need help?
General