RPC SERIES OWNER’S MANUAL
DETAILED OPERATION AND CONFIGURATION
________________________________________________________________________________
42
receptacle(s). When the command to
REBOOT (n) is sent from the RPC >
prompt, the RPC powers “Off”
corresponding outlet(s) for approximately 10
seconds, then powers them up in sequence.
This command only works on outlets which
were “On” prior to the reboot.
prior to receiving the reboot command.
Manage Users
Selection #2, “Manage Users,” from the
main menu allows the admin user to add and
delete users, change passwords, and change
the outlet list that determines an outlet user’s
access to prescribed outlets.
From the main menu, select #2, “Manage
Users.” The following menu appears:
User Management Menu
To modify existing user, enter number of user.
To add/delete user, select appropriate menu choice.
Enter request, CR to exit menus.
1) . . . Add user
2) . . . admin
If this is not an initial setup and optional
outlet users have been added, they too will
show in the User Management Menu, along
with the option to delete users.
User Management Menu
To modify existing user, enter number of user.
To add/delete user, select appropriate menu choice.
Enter request, CR to exit menus.
1) . . . Add user
2) . . . Delete user
3) . . . admin
4) . . . engineering
5) . . . sales
To Next Page
Loading...
Need help?
General