RPC SERIES OWNER’S MANUAL
RPC SERIES QUICK START (RPC-2 AND RPC-2A)
________________________________________________________________________________
2
RPC SERIES QUICK START
“Quick Start” is designed for users familiar with BayTech products who
need a fast setup and familiarization. Detailed information on each of the
functions and steps of operation and configuration may be found
beginning at pages 19, 27, and 36 of this manual. Each “Quick Start” will
discuss similar models.
RPC-2 AND RPC-2A QUICK START
EIA-232 serial
Using the 9FRJ45PC-1 adapter and the
connection
RJ08X007 cable, connect the serial port of
your computer to the RJ-45 port labeled
“EIA-232.”
Load serial port communications software.
Set serial communications parameters to
9600 bps, 8 data bits, 1 stop bit, and no
parity.
OPERATION
Accessing Main Menu
Power on the RPC unit. The following status
menu appears:
RPC-2 Series
(C) 1997 by BayTech
F2.07
Circuit Breaker : On
1) . . . OUTLET 1 : Off
2) . . . OUTLET 2 : Off
3) . . . OUTLET 3 : Off
4) . . . OUTLET 4 : Off
5) . . . OUTLET 5 : Off
6) . . . OUTLET 6 : Off
RPC >
To Next Page
Loading...
Need help?
General