RPC SERIES OWNER’S MANUAL
DETAILED OPERATION AND CONFIGURATION
________________________________________________________________________________
24
typing “CONFIG” to access the
configuration menu. If you enter the current
password correctly, the RPC responds:
Enter New Password:
Enter a new password (maximum field
length, 8 alphanumeric characters), followed
by <cr>. The RPC responds:
Re-Enter New Password:
Re-enter the new password identically to the
first entry. The password feature is case
sensitive. If you fail to re-enter the new
password correctly, the RPC responds with
an “Error” message and returns to the main
menu. Consequently, must start over by
typing CONFIG” from the RPC > prompt to
access the configuration menu. If you re-
enter the new password correctly, the RPC
returns to the main menu again, but you will
not get an “Error” message.
Disabling a Password
To disable a password, enter <cr> at the
“Enter New Password”
prompt. Enter
<cr> again at the
“Re-enter New
Password”
prompt. Changing the new
password to a carriage return disables
password protection.
Change Outlet Name
Select #2, “Change Outlet Name,” and press
<cr>. The RPC sends the following menu:
1) . . . OUTLET 1
2) . . . OUTLET 2
3) . . . OUTLET 3
4) . . . OUTLET 4
5) . . . OUTLET 5
6) . . . OUTLET 6
Enter Request:
To Next Page
Loading...
Need help?
General