RPC SERIES OWNER’S MANUAL
DETAILED OPERATION AND CONFIGURATION
________________________________________________________________________________
57
Outlet Status
The following table shows the status of all
outlets:
Outlet Status
Selection Outlet Outlet Power
Number Name Number Status
1 OUTLET 1 1 Off
2 OUTLET 2 2 Off
3 OUTLET 3 3 Off
4 OUTLET 4 4 Off
5 OUTLET 5 5 Off
6 OUTLET 6 6 Off
7 OUTLET 7 7 Off
8 OUTLET 8 8 Off
RESET UNIT
Reset the unit to load new configuration
changes.
From the main menu, select #5, “Reset
Unit.” The RPC responds:
Reset Unit? (Y/N)
Type “Y” for yes; allow approximately 5
seconds for unit reset.
Resetting the unit will not affect the power
to energized outlets.
COMMAND SUMMARY
In the following menu, “n” refers to
selection number as displayed in Outlet
Status. Any invalid input results in an input
error message and returns the user to the
command prompt.
From the RPC3> prompt in Outlet Control,
type HELP. The RPC responds with the
following command summary information.
To Next Page
Loading...
Need help?
General