BayTech RPC-2 - Command Confirmation; Outlet Power-Up Delay; Outlet Status Display

RPC SERIES OWNER’S MANUAL
DETAILED OPERATION AND CONFIGURATION
________________________________________________________________________________
51
Outlet Status Display
From the Outlet Operation Configuration
Menu, select #1, “Outlet Status Display.”
Depending on whether outlet status display
is currently enabled or disabled, the RPC
responds with the option to change the
current status.
Default setting is enabled:
Disable Outlet Status Display? (Y/N)
Command Confirmation
When a command is sent to turn on, turn off,
or reboot a receptacle, the enable/disable
confirmation feature responds by asking you
to confirm the command. For example, if
the command
ON 3
is sent, the
enable/disable confirmation responds:
Turn On Outlet 3? (Y/N)
If the enable/disable feature is disabled, the
RPC will not ask to confirm the command.
From the Outlet Operation Configuration
Menu, select #2, “Command Confirmation.”
Depending on current status, the RPC
responds with the option to change the
setting.
Default setting is enabled:
Disable Confirmation? (Y/N)
Outlet Power-Up Delay
The Outlet Power-up delay allows a set
amount of time to elapse after a unit power-
up or user initiated reset before power is
applied to the outlet. This power up
sequence is also used when a REBOOT
occurs.