RPC SERIES OWNER’S MANUAL
DETAILED OPERATION AND CONFIGURATION
________________________________________________________________________________
31
The
REBOOT n
command will reboot or
reset equipment attached to corresponding
receptacle(s). When the command to
REBOOT (n) is sent from the RPC >
prompt, the RPC powers “Off”
corresponding outlet(s) for approximately 10
seconds, then powers them up in sequence.
This command only works on outlets which
were “On” prior to the reboot.
Accessing Main Menu
Using communications software, dial the
via Modem
modem using the ATDT command. If the
modem does not respond in 5 to 7 rings, the
RPC’s RDR feature recycles power to Outlet
6 and consequently resets the modem. Dial
the modem again using the ATDT
command. When a connection has been
established, the RPC sends the following
header:
RPC-2 Series
(C) 1997 by BayTech
F2.07
If you set a password when you were locally
connected to the RPC through the serial
port, the following header appears. Note the
additional prompt for a password:
RPC-2 Series
(C) 1997 by BayTech
F2.07
Enter Password:
If prompted, enter password. The following
main menu appears:
To Next Page
Loading...
Need help?
General