Field to the right of EXIT OPERATION allows changing the name of the function.
ON and OFF Columns: There are two fields under these headings. The left columns are YES/NO toggles and the
right columns display values in seconds. Seconds values may be changed in increments of tenths of a second.
Field to the right of LINK MISC OUTPUT allows changing the output of this function to any of the Misc Outputs (1
– 8). Named Outputs 1 – 8 may not be used by this function.
Exit Operation 2 has an addition field that allows it to be configured as an EXIT DOOR UP function. It toggles
back and forth as shown / .
This feature is DOOR UP ONLY and may not be used for DOOR DOWN control. This feature would not be used if
system is equipped with an On-Board Door Control. Outputs ON time is changeable because long ON times may
interfere with some door controllers “Loop Functions”.
This system is equipped with 3 Exit Functions.
Each of these functions could utilize one, all or any combination of ON conditions. The ON condition that is met
first will turn on the functions output.
Each of these functions could utilize one, all or any combination of OFF conditions. The OFF condition that is met
first will turn off the functions output.
These functions will not operate on the vehicle unless toggled to YES in the PACKAGE SETUP.
WASH END: This is when the wash has completed its last programmed path (application). If the wash ended at the
back of the vehicle, the machine will be rapidly “HOMING” as the exit features are turning on.
EFP (End Function Pulse): This is designed to turn on exit functions while wash is still in progress. Each package
has a Pass Number and a position from completing that pass that it turns on its EFP.
EXIT1 PHOTO, Exit Door: These are all inputs that require a “light-operated” Photo-Eye (i.e. the input turns off
when the vehicle blocks the Photo-Eye beam). The ON condition for these is when the input turns off. The OFF
condition is when the input turns back on.
TREADLE: Both ON and OFF conditions are when the vehicle pulls off the wash position.
MAX-TIME: This is an OFF condition only. It’s a maximum time that a function will stay on once it turns on.
DRYER YELLOW LED: This is typically only enabled for lighted dryers that are far enough away from carriage for
one car to be in treadle position while other still getting dry. They turn yellow to not be associated with navigation
when next vehicle gets to treadle position.
To Next Page
Loading...
