CUBE® CONTROLLER
7-4 Belanger, Inc. * PO BOX 5470 * Northville, MI 48167-5470 * Ph (248) 349-7010 * Fax (248) 380-9681 1MANUL964
Chapter 7 Techniques in Programming
Foam Rain Typical Setup
The output for FOAM RAIN should be selected and named from output naming screen prior to setting up the Application
Configuration. Typically, it’s O5 that was originally WAX2. The image on the previous page shows output 012 filled in for foam.
It is recommended that 05 is used when WAX2 takes its place. See previous page for Head pneumatic setup. The Application
Setup is typically ON (FE 00) for output with output remaining on for entire pass.
To Next Page
Loading...
