Belanger Full Side Washer - Troubleshooting

FULL SIDE WASHER
1MANUL854 Belanger, Inc. * PO BOX 5470 * Northville, MI 48167 -5470 * Ph (248) 349-7010 * Fax (248) 380-9681 33
Maintenance
Troubleshooting
Problem
Solution
Wobbling Boom or Shaft
• Check for missing pieces or damaged cleaning
material
• Check Bearings for wear
• Check for bent shaft
• Check shock for leaking oil, loose bolts, or worn-out
rubber mount grommet
Boom not pivoting inward
• Confirm output is set to “AUTO” position
• Verify air feeds are in the proper location
• Confirm that air is working properly on both sides of
the air cylinder, rebuild or replace if necessary
Brush is turning too slow
• Confirm flow control setting is all the way open
• Confirm hydraulic unit has 1000 – 1100 PSI
• Replace the motor on the hydraulic unit