[P]7 TROLLING
Programming Trolling program.
• Press [P]rog and check that top row shows “Fish Program”. Change using button [3] and [6] until
row 3 shows "Trolling“.
• Press [P]rog, set Fishing depth.
• Press [P]rog, set Wheel laps.
• When done, press [P]rog or [E]nter for Main screen
The Trolling program began with Catch registration only by Wheel laps. This means that the motor
does not have to run. Catch registration is made when wheel is pulled backwards a set distance.
However today all sensors are available in Trolling program as well as Catch registration by Wheel
laps is available in all other Fishing programs. Besides best Catch registration might be a
combination of the sensors.
For availiable Catch detection sensors in this program, see Table 1 on page Machine - 4
Trolling program is made up of three main parts…
• Fishing depth[P]7[P]. The depth for fishing.
• Depth pause [E2P] is made after Fising depth is
reached.
• Wheel laps[P]7[PP] In Trolling program motor does
not start only because Depth pause has ended. Motor
starts when line is pulled outside Fishing depth with
more laps set by Wheel laps [P]7[PP]. When Fishing
depth is reached the motor stops again.
• wheel is pulled longer than the set number of
revolutions for Catch - Wheel laps [E3 PPP] located in
Menu CATCH [E3].
[P]7
Pictures Min Max Factory Step Unit Navigation
Screens in Trolling program.
Depth
Depth paus
Diagram 7
Trolling program
Time
Trolling -
Wheel laps
Catch -
Wheel laps
The diagram shows theoretically how the sinker is drawing
on an echo sounder image, with the depth of the vertical
axis and the time on the horizontal.
To Next Page
Loading...