22 Bend-Tech Dragon A400
Maintenance & Troubleshooting
Torch
04
3.
4.
request a grounding tab from Bend-Tech.
5.
mount. Place a ½ in. wrench on the nut to assist in removal.
6. Place a small amount of grease on the ground surface of the pillow block bearing. Place
the grounding tab on the ½ in. pillow block mount bolt, then place the washer. Insert the ½
in. bolt and thread it into the mounting hole. Ensure the grounding tab is positioned so it will
not interfere with the Chuck Housing.
7. Use the bolt and nut that secured the grounding cable to the carbon brush mounting system
to mount the grounding cable to the grounding tab.
8. It is recommended the Operator remove the old brush grounding components from the
Trolley assembly.
To Next Page
Loading...
