54 Bend-Tech Dragon A400
Maintenance & Troubleshooting
Miscellaneous
13
If it is determined the Rail Beam is not true, the Operator can use the swivel levelers to align
the machine.
1.
2.
Leveler. When viewing from above, turn clockwise to raise the leg, turn counterclockwise to
lower the leg.
3. Use a taut string or laser and a bubble level to measure adjustments to the machine. Also,
the Operator can sight along the length of the Rail Beam to assist in trueing the Rail Beam.
4. Once the Rail Beam is true, tighten the Swivel Levelers. Tighten the Floor Brackets.
5. After the Swivel Levers and Floor Brackets have been tightened, re-check the Rail Beam to
ensure it has remained true.
Rail Splices
Ensure that each Rail splice intersects with the next as seamlessly as possible. Ensure that all
of the Rail splices are fastened properly to the Rail.
To Next Page
Loading...
Need help?
General
