35Bend-Tech Dragon A400
Maintenance & Troubleshooting
Drive Belt
08
11.
where it rides on the Drive Pulley. The Drive Belt will drift back and forth, but it should not
contact the inside or outside Drive Pulley washers.
12. If the Drive Belt is riding too far to the inside or outside of the Drive Belt Pulley and does
not correct with tension, refer to the Drive Belt Troubleshooting documentation or contact a
Bend-Tech Service Technician.
13. When the procedure is complete, reattach the Chuck Housing. Rear Plate and E-stop
switch.
Replacing the Drive Belt
In some cases the Drive Belt may become damaged due to component failure or if material
has melted on it causing damage. In this case Drive Belt replacement may be necessary.
Drive Belt Replacement Procedure
1. Move the Trolley to the middle of Rail.
2.
the Front Plate in place.
3.
4.
front clamp block.
5.
rear clamp block.
6. Remove the old Drive Belt.
7. The new Drive Belt will be rolled up. Before unrolling the new Drive Belt, clamp one end
in front clamp block. Ensure the new Drive Belt is positioned up against outer clamp block
screws. Ensure the new Drive Belt is fed all the way to the front of the clamp block.
Tools Needed
•
•
• ¾ in. wrench
• Drive Belt tensioning tool
Materials Needed
• New Drive Belt
To Next Page
Loading...
