38 Bend-Tech Dragon A400
Maintenance & Troubleshooting
Drive Belt
08
Adjusting Belt Tension
1. Using a ¾ in. wrench or ¾ deep well socket, remove the lock nut from the Drive Belt
Tensioning Block adjustment stud.
2. To adjust Drive Belt tension, use a ¾ in. wrench or deep well socket to turn the adjusting
nut. Turn clockwise to increase tension, turn counterclockwise to reduce tension.
3. To lock in Drive Belt tension, thread the second ¾ in. nut onto the Drive Belt Tensioning
Block adjustment Stud. Tighten the locking nut with a ¾ in. socket and ratchet or ¾ in.
wrench against the adjustment nut by turning it clockwise.
4. Re-check Drive Belt tension.
Tension Nut
Locking Nut
Pins
Rear Belt Clamp
To Next Page
Loading...
