36 Bend-Tech Dragon A400
Maintenance & Troubleshooting
Drive Belt
08
8. Unroll the Drive Belt along the length of the machine. Take care to keep the Drive Belt from
9. Feed the Drive Belt around the idler pulleys and Drive Belt Pulley. Ensure there’s no slack
in the Drive Belt.
10. Ensure the rear Drive Belt Adjustment Block screws are backed out as much as possible.
Feed the Drive Belt through the clamp. Position the Drive Belt Adjustment Block so the
adjustment block pins on the machine are even with the two most rearward screws on the
clamp block. Hold the clamp block in place with one hand and pull the Drive Belt tight with
the other hand.
11.
the clamp on the Drive Belt.
12. Feed the Drive Belt Adjustment Block stud through the hole and position the block onto the
locating pins.
13. Thread the adjustment nut(s) onto the stud.
14. Perform the Drive Belt Tensioning procedure.
Checking Drive Belt Tension
The Drive Belt should already be installed and the Trolley positioned at the center of the Rail
travel.
1. Lay a tape measure on the cable track with 0 on the ruler positioned where the Drive Belt
enters the Drive Belt Clamp Block.
2. Using the Belt Tension Tool from the Miscellaneous box, position the tool one foot from the
Drive Belt Clamp Block.
3.
Drive Belt Pull Tight
Line up ends of pins
with rear two clamp
screws; clamp belt in
this position.
Pins
To Next Page
Loading...
