39Bend-Tech Dragon A400
Maintenance & Troubleshooting
Chuck
09
09
Chuck
Chuck Troubleshooting
Symptom Cause Corrective Action
Chuck skipping steps
Breakout Board not seated
in motor drivers.
Ensure the Breakout Board is fully
seated in the Motor Drivers.
Y Motor has come loose.
Remove the Chuck Housing and
perform a visual inspection of the Y
Motor. Check to ensure the Y Motor is
secure.
Chuck not level in load
position
Y gear has slipped/come
loose.
Remove Chuck Housing and inspect Y
gear and Y Motor drive gear. If either
one is loose, re-tighten.
Y Motor skipped steps.
seated in the Motor Drivers.
Ensure cables are in working order
and not damaged.
Y Axis not homed.
In the Bend-Tech Dragon home
interface, click Machine Control. In the
top right hand corner click the home
icon next to the Y Axis, or click Home
All Axis.
To Next Page
Loading...
