25Bend-Tech Dragon A400
Maintenance & Troubleshooting
Material Support Lift
06
06
Material Support Lift
Material Support Lift Guide
Material Support Lift Settings In Bend-Tech 7x
The Material Support Lift should be calibrated before machine use. Before beginning, ensure
Material Lifter is checked in the Material Support box on the Machine Library Main interface.
are determined during the machine calibration process. Once the Material Support Lift is
calibrated, the Operator should not need to adjust these settings.
Change the Support Lifter Gap
In the Tube Library, in the Machine interface, the Operator can change the Lifter height by
entering the desired value in the Support Lifter Gap text box. The Support Lifter Gap is typically
set to zero. However, in the case of some larger materials, such as large square or rectangle
material, the lifter may need to be set to compensate for material size. If the Material Support
Lift is binding and/or skipping steps when processing large material, it may be necessary to
change the Support Lifter Gap. Contact a Bend-Tech Service Tech before changing these
settings.
To Next Page
Loading...
Need help?
General
