CC612(4G)_D00325_04_M_XXEN/03.2019
7
Safety information
2. Safety information
2.1 General safety instructions
Part of the device documentation in addition to this manual is the enclosed "Safety
instructions for Bender products".
2.2 Work activities on electrical installations
If the device is being used in a location outside of Germany, the applicable local standards
and regulations must be complied with. European standard EN 50110 can be used as a
guide
2.3 Dangers dealing with the charge controller
The CC612 charge controller has been assembled in accordance with the latest state-of-
the-art technology and recognized safety rules. Nevertheless, its use may result in injury
to the user or a third party respectively, through interference or damage to the charge
controller or material property. The charge controller must only be used for its intended
purpose.
2.4 Precautions
Ensure the correct rated input voltage and supply voltage is applied. To check that the
device has been properly connected, perform a functional test before commissioning the
system. Refer to Chapter 6.6.
DANGER
Risk of fatal injury from electric shock!
Touching live parts of the system carries the risk of:
• An electric shock
• Damage to the electrical installation
• Destruction of the device
Before installing and connecting the device, make sure that the installati-
on has been de-energised. Observe the rules for working on electrical ins-
tallations.
2.5 Intended use
The CC612 charge controller, hereafter referred to as the charge controller, is the main
component of a charging system and is designed for use in electric vehicle (EV) charging
stations, wall boxes and street light charging points. The charge controller controls type
1 and type 2 plugs, and type 1 and type 2 sockets. It enables a setup that is in accordance
with current standards, such as IEC 61851-1, EN 61851-22 and IEC 60364-7-722.
Any use other than that described in this manual is regarded as improper.
This manual is intended for qualified personnel working in
electrical engineering and electronics!
To Next Page
Loading...
Need help?
General
