Configuration and testingConfiguration and testing
CC612(4G)_D00325_04_M_XXEN/03.2019
28
6.2 State tab
Parameter Description
ChargePoint ID (OCPP)
OCCP Charge Point ID which is used to identify
itself towards the backend system. If two or
more Slave devices are connected, each Slave
must identify itself to the Master with its respec-
tive connector ID added as a suffix. E.g. #2 or
#005 should be appended to the Charge Point
ID. Please note that suffixes #, #0 or #1 are reser-
ved and cannot be used.
OCPP State (connector 1) State of OCPP at connector 1
Type2 State (connector 1) State of type 2 socket at connector 1
Signaled current The current in Ampere that is signaled to the
vehicle via PWM.
Schuko State (connector 1) State of Schuko socket at connector 1
Connection State (Backend) The current state of the backend connection on
TCP level
Connection State (Modem) Show at which state in the connection sequence
the modem is currently operating. Show "OK"
when connected.
Free charging This mode allows charging without authoriza-
tion via RFID or the backend. Charging is started
immediately after a vehicle is connected.
Free charging mode This allows to set the OCPP behaviour in free
charging mode. Note that in case of Master/
Slave scenario the Slave will be automatically
configured to the same mode the Master uses.
Errors list List of errors that are currently present in the
charge point
RCMB protection state RCMB protection state
Requested 3G Network operator The name of the network operator to be used in
manual mode. If operator name is unknown, set
the "Scan network operators at boot" parameter
to "On", then click on "Save & Restart". Then, in
the State tab all the available operator names
will be shown.
Currently used 3G Network opera-
tor
The name of the network operator the built-in
4G modem is currently connected to.
Network registration mode The current network registration mode of the 4G
modem which informs about the technology
(2G, 3G, 4G) and about the registration (home
network, roaming etc.).
Network registration state The registration state to the mobile network
Modem access technology Shows which access technology (2G, 3G, 4G) the
modem is currently using.
Scan network operators at boot
Determines whether upon boot a search for
available network operators is carried out. The
result can then be requested as separate
parameter. The value is automatically set to "Off"
after boot.
Operator Selection Mode Operator selection mode, auto or manual etc.
Mobile country code (MCC)
Mobile Country Code as determined from the
SIM card. This tells you which country your SIM
card comes from.
Mobile Network Code (MNC)
Mobile Network Code as determined from the
SIM card. This tells you which mobile network
operator your SIM card comes from.
Location area code (LAC)
Location Area Code as reported by the built-in 4G
modem, this value can be used to determine the
location of the charge point.
Cell id
Cell ID as reported by the built-in 4G modem, this
value can be used to determine the finer location
of the charge point.
Receive Signal Strength Indicated
(RSSI)
Receive Signal Strength Indicator as reported by
the 3G-Modem. This parameter is an indication
how well the built-in modem can receive signals
from the base station.
Values meaning: [0: Extremely low], [1: Very low],
[2-12: Low], [13-30: Good], [99: Unknown or
undetectable]
Additional modem information
Shows the modem manufacturer, model and
firmware.
Meter configuration (OCPP)
The type of meter used for the charging socket
and its connector. This is relevant for OCPP
transactions.
Parameter Description
To Next Page
Loading...
