[ ] (PLAY) Snapshot Screen [SET] MENU PLAY Tab
Voice Memo
2. Press [SET] again to stop audio recording.
• Take care that you do not block the camera’s microphone with
your fingers while recording.
• Good recording results are not possible when the camera is too
far away from what you are trying to record.
• Your camera supports the following audio data formats.
– Audio Format: WAV extension
• You cannot add audio to an image that is protected.
• To delete audio, perform the following operation:
Voice Memo Delete [SET] [ ] (Delete).
IMPORTANT!
• Note that you cannot restore the original audio of an Audio Snapshot after you delete or
re-record it.
1. In the PLAY mode, use [ ] and [ ] to scroll through the images until the
Audio Snapshot you want is displayed.
An audio snapshot is one that has a icon.
2. Press [ ] (Movie) to start playback.
Adding Audio to a Snapshot (Voice Memo)
You can add audio to a snapshot after you shoot it. You can
re-record a snapshot’s audio whenever you want. You can
record up to about 30 seconds of audio for a single
snapshot.
1. Press [SET] to start audio recording.
Remaining recording time
To play snapshot audio
To Next Page
Loading...
