[SET] MENU Set Up Tab USB
You can use the procedure below to select the USB communication protocol, which is used
when exchanging data with a computer, printer, or other external device.
[SET] MENU Set Up Tab TV Out
You can use the procedure in this section to select either NTSC or PAL as the video output
system. You can also specify an aspect ratio of 4:3 or 16:9.
• Select the aspect ratio (4:3 or 16:9) that matches the type of TV you plan to use. Images
will not display correctly if you select the wrong aspect ratio.
• Images will not display correctly unless the camera’s video signal output setting matches
the video signal system of the TV or other video equipment.
• Images cannot be displayed correctly on a TV or video equipment that is not NTSC or
PAL.
Configuring USB Protocol Settings (USB)
Mass Storage
Select this setting when connecting to a computer. With this setting, the
computer sees the camera as an external storage device. Use this setting
for normal transfer of images from the camera to a computer.
PTP
(PictBridge)
Select this setting when connecting to a printer that supports PictBridge.
This setting simplifies the transfer of image data to the connected device.
Selecting the Screen Aspect Ratio and Video Output System (TV Out)
NTSC Video system used in Japan, the U.S., and other countries
PAL Video system used in Europe and other areas
4:3 Normal TV screen aspect ratio
16:9 Wide screen aspect ratio
Downloaded From camera-usermanual.com BenQ Manuals
To Next Page
Loading...
Need help?
General
