[SET] MENU Set Up Tab Startup Image
Display the image you want to use as your startup image and then select “On”.
• The startup image does not appear when you turn on the camera by pressing [ ]
(PLAY).
• You can specify a snapshot you recorded as the startup image, or you can use the special
startup image provided in the camera’s built-in memory.
• If you select an audio snapshot as the startup image, the audio will not play at startup.
• Formatting built-in memory will delete the current startup image setting.
[SET] MENU Set Up Tab File Numbering
Use the following procedure to specify the rule that governs generation of the serial number
used in file names.
Configuring a Startup Image
Specifying the File Name Serial Number Generation Rule
(File Numbering)
Continue
Tells the camera to remember the last used file number. A new file will be
named using the next sequential number, even if files are deleted or if a blank
memory card is loaded. If a memory card is loaded and that card already has
files stored on it and the largest sequential number in the existing file names
is greater than the largest sequential number remembered by the camera,
numbering of new files will start from the largest sequential number in the
existing file names plus 1.
Reset
Restarts the serial number from 0001 whenever all files are deleted or when
the memory card is replaced with a blank one. If a memory card is loaded
and that card already has files stored on it, numbering of new files will start
from the largest sequential number in the existing file names number plus 1.
Downloaded From camera-usermanual.com BenQ Manuals
To Next Page
Loading...
Need help?
General
