Bernette b68 AIRLOCK - Preparing the Thread Guide; Attaching the Spool Stabilizer

Setting Up the Machine
27
2022-05 EN 50400685.00A.04
Preparing the Thread Guide
The thread guide ensures a clean unwinding of the thread from the thread cones. Each thread is guided
through a thread guide wire located directly above the thread cone.
> To attach the retractable thread guide, insert the thread guide into the provided opening in the spool
holder until it clicks.
> Hold the thread guide and pull it up to the stop.
> Turn the thread guide to the left and right until the two positioning pins engage.
– The outer thread guide wires are parallel to the machine front.
> To retract the thread guide, push the thread guide down with a little pressure.
Attaching the Spool Stabilizer
For large thread cones, the spool stabilizer serves to stabilize the thread cone on the spool pin.
> For extremely conical spools, place the spool stabilizer onto the thread spool pin with the pointy end up.
> For slightly conical spools, place the spool stabilizer onto the thread spool pin with the pointy end down.