Setting Up the Machine
31
2022-05 EN 50400685.00A.04
NOTICE
Damage due to Excessive Tightening of the Screws
The threads of the needle holder may be damaged. A repair by the authorized bernette dealer is required.
> Do not overtighten the needle screws.
Prerequisite:
• The needles are in the top position.
• The presser foot is raised.
> Hold the needle and loosen the needle screw from the threader cover using the screwdriver supplied.
> Remove the needle downwards and store it in the needle pad.
> Insert the new needle with the flat side to the back into the needle inserter.
> Push the needle into the corresponding needle holder opening as far as it will go.
> Check the needle position in the needle checking window.
> Tighten the needle screws.
Positioning the Needles Up/Down
The needle position up/down is recommended for various actions.
• to change the needle
• to thread the needle
To Next Page
Loading...
