Bernette b77 - Checking the Stitch Plate in the User Interface

Sewing Preparation
33
2022-08 EN 5020077.40A.04
Checking the Stitch Plate in the User Interface
After changing the stitch plate, you can check whether it can be used with the selected needle.
> Tap «Stitch Plate/Needle Selection».
– The mounted stitch plate is automatically detected and shown in the display.
– If the selected stitch plate is suitable to be used in combination with the needle, sewing can begin.
– The stitch width is automatically set to the permissible value.
– If the selected needle does not match with the stitch plate, a red exclamation mark will appear on the
display.