Sewing Preparation
37
2022-08 EN 5020077.40A.04
> To cut off excess thread, take the thread end and carefully pull it over the thread cutter. Please Note:
Use the right thread cutter only when threading.
> To thread the needle, lift the needle-threading lever. Keep the thread loose when doing so.
– The wire hook moves backwards and pulls the thread through the needle eye into a loop.
> Pull the thread completely through the eye of the needle.
Threading the Twin Needle
Prerequisite:
• The zigzag foot is fitted.
• The twin needle is inserted.
• The second spool pin, felt disc and second spool are fitted.
> Guide the thread from the horizontal spool pin (red) in the direction of the arrow to the left side of the
thread tension disc (1).
To Next Page
Loading...
