EasyManua.ls Logo

Beta EVO 2T - Coolant; Check the Level

Beta EVO 2T
68 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
4
CHECKS AND MAINTENANCE
35
GB
COOLANT
CHECK THE LEVEL
Keep the vehicle in vertical position relative
to the ground.
The level of the coolant must be checked
when the engine is cold. Use the following
procedure:
- Unscrew cap 1 and ensure that the liq-
uid is visible in the lower portion of the
loading tube.
- Where the liquid is not visible in the lower
part of the loading tube position the
vehicle as in the figure and then top up.
- At the end of operation refit the filler cap
and the vent screw.
Use the liquid indicated on page 18 in
the “Recommended lubricants and liquids”
table.
WARNING: Never unscrew the
filler cap of the radiator when the
engine is hot. Danger of burning!
WARNING:
Wear appropriate protective cloth-
ing and protection gloves.
Keep coolant out of reach of chil-
dren.
Avoid any direct contact of the cool-
ant with skin, eyes or clothing. If this
happens:
- with the eyes, rinse immediately with
plenty of water and seek medical advice;
- with skin, Immediately clean contaminat-
ed areas with soap and water Change
clothing that is contaminated with cool-
ant.
If coolant is swallowed, contact a doctor
immediately.
1

Table of Contents

Other manuals for Beta EVO 2T

Related product manuals