4
CHECKS AND MAINTENANCE
59
GB
CLEANING THE VEHICLE
GENERAL PRECAUTIONS
WARNING: Do not clean your vehicle with a high-pressure device with a
strong jet of water. Excessive pressure can reach electrical components, con-
nectors, flexible cables, bearings, etc and can damage or destroy them.
WARNING: Wash motorbikes frequently with cold water that are used near
the sea (salty air) and on roads subject to salt spreading in winter. Cover with
a film of oil or silicone spray unpainted parts and the most exposed parts such
as wheels, forks and swingarm. Do not treat rubber parts and brakes.
When cleaning, avoid direct exposure to sunlight.
Close off the exhaust system to prevent water from entering.
Avoid directing the jet of water onto the air filter box cover and the carburettor.
WASHING MODE
Use water jet to soften the dirt and mud accumulated on the paintwork, then remove
them with a soft bodywork sponge soaked in water and shampoo. Subsequently
rinse well with water, and dry with air and cloth or suede leather.
Detergents pollute water. Always wash the vehicle in areas equipped for collection
and purification of the washing liquids.
AFTER WASHING
Proceed to the emptying of the filter box using the appropriate ventilation and drying.
After cleaning, ride a short distance until the engine reaches operating temperature.
WARNING: braking effect is reduced with wet brakes. Operate the
brakes cautiously to allow them to dry.
Push back the handlebar control covers, so that water can evaporate.
When the bike is completely dry and cooled down, lubricate all moving parts.
Treat all plastic and painted components with non-aggressive detergents or products
that are specific for the care of the motorcycle.
To Next Page
Loading...
Need help?
General
