Beta EVO 2T User Manual

4
CHECKS AND MAINTENANCE
47
GB
CLUTCH CONTROL
CHECK OIL LEVEL
To check the oil level in the clutch pump,
first remove cover 1.
Remove the two screws 2 and take off
cover 1 together with the rubber bellows.
With the clutch pump in a horizontal posi-
tion, the level of the oil should be 5 mm
below the upper rim.
Use the liquid indicated on page 18 in
the “Recommended lubricants and liquids”
table.
WARNING:
The brake fluid is extremely corro-
sive. Take care not to spill it on the
paintwork.
Wear appropriate protective cloth-
ing and protection gloves.
Keep coolant out of reach of chil-
dren.
WARNING: Avoid any direct con-
tact of the liquid with skin, eyes or
clothing. If this happens:
- with the eyes, rinse immediately with
plenty of water and seek medical advice.
- with skin, immediately clean contaminat-
ed areas with soap and water. Change
clothing that is contaminated with liquid.
If liquid is swallowed, contact a doctor
immediately.
2
1

Beta EVO 2T Specifications

General

Displacement	249 cc
Cooling System	Liquid cooled
Transmission	6-speed
Bore x Stroke	66.4 mm x 72 mm
Clutch	Wet multi-disc
Dry Weight	67 kg
Engine Type	2-stroke single
Front Suspension	Telescopic fork
Rear Suspension	Monoshock
Front Brake	Single disc
Rear Brake	Single disc
Fuel Capacity	2.5 liters
Frame	Aluminum