EasyManua.ls Logo

Beta EVO 2T - Bleeding the Rear Brake

Beta EVO 2T
68 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
4
CHECKS AND MAINTENANCE
45
GB
1
2
WARNING:
The brake fluid is extremely corro-
sive. Take care not to spill it on the
paintwork.
Wear appropriate protective cloth-
ing and protection gloves.
Keep coolant out of reach of chil-
dren.
WARNING: Avoid any direct con-
tact of the liquid with skin, eyes or
clothing. If this happens:
- with the eyes, rinse immediately with
plenty of water and seek medical advice.
- with skin, immediately clean contaminat-
ed areas with soap and water. Change
clothing that is contaminated with liquid.
If liquid is swallowed, contact a doctor
immediately.
BLEEDING THE REAR BRAKE
To bleed air from the rear brake circuit,
proceed as follows:
Remove the rubber cap 1 from the valve
2.
• Open the sump cap.
Insert one end of a transparent tube into
a container.
Pump with the brake lever 2/3 times
and keep the lever pressed.
• Unscrew the valve and let the oil drain.
If are still visible in the tube repeat above
operation until obtaining a continuous
outflow of oil within no air bubbles.
Close the valve and release the lever.

Table of Contents

Other manuals for Beta EVO 2T

Related product manuals