4
CHECKS AND MAINTENANCE
46
GB
2 mm
REAR BRAKE LINING CONTROL
In order to verify the wear condition of rear
brake is enough to view the caliper from the
back side, where is possible to glimpse the
brake lining tails which will have to show
a brake of 2 mm in thickness. If the stratum
is lesser let’s start replacing them.
NOTE:
Perform the check according to the times
shown in the table on page 61.
To replace, contact authorised Betamotor
customer service.
NOTE:
During this procedure, continuously top up the brake pump thank to replace the oil
that is out flowing.
•Remove the tube.
•Replace the rubber cap.
Close the oil reservoir cap.
Use the liquid indicated on page 18 in the “Recommended lubricants and liquids”
table.
WARNING:
The brake fluid is extremely corrosive. Take care not to spill it on the paintwork.
Wear appropriate protective clothing and protection gloves.
Keep coolant out of reach of children.
WARNING: Avoid any direct contact of the liquid with skin, eyes or clothing.
If this happens:
- with the eyes, rinse immediately with plenty of water and seek medical advice.
- with skin, immediately clean contaminated areas with soap and water. Change
clothing that is contaminated with liquid.
If liquid is swallowed, contact a doctor immediately.
To Next Page
Loading...
Need help?
General
