Beta RR 350 User Manual

4
CHECKS AND MAINTENANCE
37
GB
To change the paper fi lter, remove the oil
tap form engine unscrewing the two screws
3. Using special seeger ring pliers, pull the
paper oil fi lter.
3
Mount the new paper fi lter, close the oil tap
to engine, tighten the screws at 10 Nm.
Pour in the quantity of liquid indicated on
page 11.
Use the oil indicated on page 14 in
the “Recommended lubricants and liquids”
table.
- Screw on fi ller cap 1 again.
- Start the engine and run at idle for a few
minutes.
- Turn off the engine and wait for about one
minute, then check the level and top up
if needed, without exceeding the upper
edge of the inspection window .
WARNING:
Hot oil can cause severe burns!
ATTENTION:
Dispose of used oil in compliance with the
regulations in force.
10Nm
1

Beta RR 350 Specifications

General

Bore x Stroke	88 mm x 57.4 mm
Ignition	DC-CDI
Lubrication	Wet sump
Transmission	6-speed
Clutch	Wet multi-disc
Front Brake	260 mm disc
Rear Brake	240 mm disc
Front Tire	90/90-21
Rear Tire	140/80-18
Seat Height	940 mm
Ground Clearance	320 mm
Dry Weight	107 kg
Rear Suspension	Sachs shock absorber
Fuel Capacity	9.5 liters