Beta RR 350 User Manual

4
CHECKS AND MAINTENANCE
54
GB
CHECK FOR CHAIN WEAR
Shift into neutral, pull up the upper stretch
of the chain with a force of 10 - 15 kg (see
fi gure). Measure the length of 18 links on
the lower stretch of the chain. If the length
is ≥ 272 mm, replace the chain. Chains
do not always wear evenly. For this reason
it is important that the measurement is taken
at different points along the chain.
When fi tting a new chain, be sure to re-
place the chainring and sprocket as well.
New chains wear more quickly if fi tted on
old and worn sprockets. After replacing
the chain, adjust its tension as described
on page 53.
10 -15 Kg
OK < 272
18 steps
• Loosen counternuts A on either side of the
fork.
• Turn adjusting screws B on either side until
the desired chain tension is obtained
• Tighten counternuts A on either side of
the fork
• Tighten the pin 1 to the torque indicated..
A
B
1
130Nm

Beta RR 350 Specifications

General

Bore x Stroke	88 mm x 57.4 mm
Ignition	DC-CDI
Lubrication	Wet sump
Transmission	6-speed
Clutch	Wet multi-disc
Front Brake	260 mm disc
Rear Brake	240 mm disc
Front Tire	90/90-21
Rear Tire	140/80-18
Seat Height	940 mm
Ground Clearance	320 mm
Dry Weight	107 kg
Rear Suspension	Sachs shock absorber
Fuel Capacity	9.5 liters