4
CHECKS AND MAINTENANCE
45
GB
2mm
FRONT BRAKE LINING CONTROL
In order to verify the wear condition of front
brake is enough to view the caliper from
the bottom, where is possible to glimpse
the brake lining tails which will have to
show a brake of 2 mm in thickness. If the
stratum is lesser let’s start replacing them.
NOTE:
Perform the check according to the times
shown in the table on
page 61.
To replace, contact authorised Betamotor
customer service.
A
1
REAR BRAKE
CHECK THE LEVEL OF THE REAR
BRAKE FLUID
Check the level of the brake fl uid through
sight A. The level of the fl uid should never
fall below the mark in the sight.
RESTORING THE LEVEL OF THE
REAR BRAKE FLUID
To restore the oil level, top up by means
of oil fi ller cap 1.
Use the liquid indicated on page 14 in
the “Recommended lubricants and liquids”
table.
WARNING
The brake fl uid is extremely corrosive. Take
care not to spill it on the paintwork.
To Next Page
Loading...
