Beta RR 350 User Manual

4
CHECKS AND MAINTENANCE
55
GB
HEADLIGHT
Keep the headlight glass clean at all times
(see page 59).
Periodically check the correct angle of the
light beam.
REPLACING THE
HEADLIGHT BULBS
Release both spring washers and move
forward the lamp holder front cowl.
Carefully remove the headlight bulb 1
together with lamp holder. To replace the
high beam / low beam, lift the rubber
cover 2, release connector, push on the
spring 3 and remove the lamp holder and
replace the light bulb with a new one. Be
careful not to touch the bulb so as not to
compromise its effi ciency.
To refi t, follow the procedure above but in
reverse order.
Fasten the lamp holder front cowl to the
supporting pins and fi x it with the two
elastics.
1
2
3
TAIL LIGHT
Keep the tail light glass clean at all times
(see page 59).
The LED tail light is sealed. In the case of
burnout of one or more LEDs it is necessary
to replace the entire group.
To replace, contact authorised Betamotor
customer service.

Beta RR 350 Specifications

General

Bore x Stroke	88 mm x 57.4 mm
Ignition	DC-CDI
Lubrication	Wet sump
Transmission	6-speed
Clutch	Wet multi-disc
Front Brake	260 mm disc
Rear Brake	240 mm disc
Front Tire	90/90-21
Rear Tire	140/80-18
Seat Height	940 mm
Ground Clearance	320 mm
Dry Weight	107 kg
Rear Suspension	Sachs shock absorber
Fuel Capacity	9.5 liters