Beta RR 350 - Engine, Fluids, and Ignition Maintenance

4
CHECKS AND MAINTENANCE
36
GB
ENGINE OIL
CHECK THE LEVEL
When engine is cold check the oil level by
means of porthole 1. The oil level must be
always visible from the porthole.
In contrary case restore the oil level through
cap 2
up to the upper edge of the inspec-
tion window.
Use the oil indicated on page 14 in
the “Recommended lubricants and liquids”
table .
REPLACEMENT
Always perform the replacement when
engine is hot:
- Position the drive on a fl at base ensuring
stability.
- Remove the engine casing by loosening
the screws shown in the fi gure.
- Place a container under the engine.
- Unscrew fi ller plug 1 and drain plug 2.
- Remove the wire mesh fi lter.
- Drain all the oil from the crankcase.
- Thoroughly clean the drain plug, the wire
mesh fi lter and the sealing surfaces.
- Mount the wire mesh fi lter and the drain
plug.
- Tighten to the torque indicated.
1
2
2
1
15Nm