22
> Press/release the S (Select/Right) button until the desired Alarm
value appears, or press/hold the button to scroll through the Set
Points at a rate of 4 set points per second.
> Press/release the A (Advance/Left) button to accept the setting
and advance to Set A - C (Ascent - Chrono) Mode, or press/hold
Both buttons for 2 seconds to revert to the SET 1 screen.
• Operation reverts to the NORM SURF MAIN in 2 minutes if no
button is pressed.
SET A - C (ASCENT - CHRONO) MODE
The d.i.P is configured with a Chronograph Mode and a Mode that
provides a digital display of Ascent Rate. This setting selects
which Mode is to be used and which is to be disabled, or if both
are to be disabled. There are 3 screens of information.
To access the Set A - C Mode screen while viewing the SET 1
screen, press/release the A (Advance/Left) button 3 times (< 2 sec-
onds each time).
• If both Modes were previously set OFF, the graphics A - C and
OFF appear with OFF flashing (Fig. 17).
• If Ascent Mode was previously set ON, the graphics ASC, A,
and ON appear with ON flashing (Fig. 18).
• If Chrono Mode was previously set ON, the graphics CHR, C,
and ON appear with ON flashing (Fig. 19 on page 23).
Fig. 17 - SET A - C (BOTH OFF)
Fig. 18 - SET ASCENT MODE
To Next Page
Loading...
Need help?
General
