23
> Press/release the S (Select/Right) button repeatedly (< 2 seconds
each time) to step through the 3 selections
> Press/release the A (Advance/Left) button to accept the selec-
tion displayed and advance to Set GLO (Backlight Duration), or
press/hold Both buttons for 2 seconds to revert to the SET 1
screen.
• Operation reverts to the NORM SURF MAIN in 2 minutes if no
button is pressed.
SET GLO (BACKLIGHT DURATION)
Backlight Duration is the Length of Time (0, 5, or 10 seconds) that
the Backlight will remain ON when the S (Select/Right) button
used to activate it is released.
NOTE: During operation in NAV Mode, Backlight
Duration is active when NAV Backlight Mode (a
NAV Mode setting) is set for Time Out. When Back-
light Mode is set for Constant, the Backlight will re-
main ON until it is turned OFF and not Time Out.
To access the Set GLO (Backlight Duration) screen while viewing
the SET 1 screen, press/release the A (Advance/Left) button 4
times (< 2 seconds each time).
• The graphic GLO will appear with the Duration Time value
flashing (Fig. 20).
Fig. 19 - SET CHRONO MODE
Fig. 20 - SET GLO
To Next Page
Loading...
Need help?
General
